The easyrace set on a desk: the printed steering wheel on the left, the three pedals on their base plate in the middle and the H-pattern shifter on the right, with workshop drawers and a pegboard behind them
Close-up of the printed steering wheel with the MandićLab logo on its hub, the pedals standing behind it
The three pedals seen from the side, with the green, red and blue printed springs behind them and the wiring running along the frame
Close-up of the H-pattern shifter: the silver knob in its printed gate, with the pedal plate beside it on the desk

easyrace

Digital product

You buy the 3D models and the firmware from us. The filament and the electronics you buy yourself. The assembly tutorial is free for everyone on YouTube, and updates are free for life.

Easyrace is a fully 3D printable DIY sim racing setup that you can make at home without special tools, skill or knowledge.

Easyrace consists of:
easysteer — steering wheel
easydrive — pedals
easyshift — H-pattern shifter
easyshift — sequential shifter

easydrift — handbrake

Unlike any other DIY sim racing equipment, everything here is 3D printed. No screws, nuts, springs, sliders, shafts, bearings or similar mechanical parts are needed.

The electronics are reduced to the minimum, chosen to be affordable and reliable, and easy to source anywhere.

The building process is very simple. Everything has its own place, the amount of parts is reduced to a minimum, no special tools are required and everything is well explained in a video tutorial.

Starter
$40
$35
SAVE 13%
BUY the Starter bundle
Core
$60
$50
SAVE 17%
BUY the Core bundle
Pro
$110
$69
SAVE 37%
easysteer — steering wheel
easydrive — pedals
easyshift — H-pattern shifter
easyshift — sequential shifter
easydrift — classic handbrake
easydrift — hydraulic handbrake
Lifetime Free Updates
What you need
Parts
3D printing filament
≈ 2336 g
≈ 2756 g
≈ X g
Pro Micro
ATmega32U4 — USB Type-C
2x
3x
6x
Potentiometer
WH148 10k Linear
4x
6x
8x
Switch
KW11-3Z-B
2x
2x
4x
Wire
≥ 24 AWG
X m
X m
X m
Tools
3D printer
minimum 200 × 200 mm build plate
Soldering iron
Super glue
Compatibility
Works with most racing games.